Croslynk Engineering House runs simulation, materials, tooling, manufacturing and testing for elastomer components under one roof. What leaves our floor has already passed its test.
Use one on its own, or let each hand its data to the next. Every service has its own page with the detail.
01Simulation Services
We fit a hyperelastic model to your compound and run the part under its service load, so stiffness and fatigue life are known before a mould is cut.
02Specialized Materials
Fifty grades across rubber, cast polyurethane, TPU, TPE and tool steels, laid out as one periodic table. Every lot ships with its TDS, SDS and batch certificate.
03Tooling Services
Cast PU dies, compression and injection moulds, jigs and fixtures, and the machined inserts that bond into your part, measured before they leave the tool room.
04Manufacturing Services
Hot-cast polyurethane, TPU and TPE injection, rubber compression moulding and 3D printing. We pick the route from your part and your volume, and check every batch at three points.
05Testing Services
The static lab tests the compound; the dynamic lab loads the finished part the way it will be fitted. Each result names its method and its limit.
The same sine load runs on a servo-hydraulic frame, on the finished part, for millions of cycles.
Case studies
Each study starts with the question we were asked and ends in a design decision you can build.
R-02Railway
Soft enough to let the wheelsets steer, stiff enough to stop them hunting.
DecisionTwo options with the same steering stiffness and up to 40 % less strain at the bond.
Send it to us. You get a plan, a price and a lead time within 48 hours.
